C613-50100-01 REV C Command Reference for x930 Series 1140
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
OSPFV3 FOR IPV6 COMMANDS
SHOW
IPV6 OSPF VIRTUAL-LINKS
show ipv6 ospf virtual-links
Overview Use this command in User Exec or Privileged Exec modes to display virtual link
information, including OSPFv3 Authentication status for virtual links.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show ipv6 ospf virtual-links
Mode User Exec and Privileged Exec
Usage See the OSPFv3 Feature Overview and Configuration Guide for more information
and examples.
Examples To display virtual link information, use the command:
awplus# show ipv6 ospf virtual-links
Output Figure 27-17: Example output from the show ipv6 ospf virtual-links command
showing OSPFv3 Authentication configuration information
highlighted in bold
Related
Commands
area virtual-link authentication ipsec spi
area virtual-link encryption ipsec spi
awplus#show ipv6 ospf virtual-links
Virtual Link VLINK1 to router 192.168.1.10 is down
Transit area 0.0.0.1 via interface *, instance ID 0
Local address
Remote address
MD5 Authentication SPI 1000
NULL encryption SHA-1 auth SPI 1001
Transmit Delay is 1 sec, State Down,
Timer intervals configured, Hello 10, Dead 40, Wait 40,
Retransmit 5
Hello due in inactive
Adjacency state Down
To Next Page
Loading...
Need help?
General
