Allied Telesis AlliedWare Plus - Page 1139

C613-50100-01 REV C Command Reference for x930 Series 1139
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
OSPFV3 FOR IPV6 COMMANDS
SHOW
IPV6 OSPF ROUTE
Output Figure 27-16: Example output from the show ipv6 ospf P10 route command for
a specific process
OSPFv3 Process (P1)
Codes: C - connected, D - Discard, O - OSPF, IA - OSPF inter 
area
E1 - OSPF external type 1, E2 - OSPF external type 2

Destination Metric
Next-hop
O 2002:1111::/64 2
via fe80::200:cdff:fe24:daae, vlan3, Area 0.0.0.0
C 2003:1111::/64 1
directly connected, vlan3, Area 0.0.0.0
O 2004:1111::/64 3
via fe80::200:cdff:fe24:daae, vlan3, Area 0.0.0.0
C 2005:1111::/64 1
directly connected, vlan5, Area 0.0.0.0
E2 2010:2222::/64 1/20
via 2003:1111::1, vlan3
E2 2011:2222::/64 1/20
via 2003:1111::1, vlan3
E2 2012:2222::/64 1/20
via 2003:1111::1, vlan3
E2 2013:2222::/64 1/20
via 2003:1111::1, vlan3
E2 2014:2222::/64 1/20
via 2003:1111::1, vlan3
E2 2015:2222::/64 1/20
via 2003:1111::1, vlan3