C613-50100-01 REV C Command Reference for x930 Series 384
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
LOGGING COMMANDS
LOG
PERMANENT
log permanent
Overview This command configures the device to send permanent log messages to
non-volatile storage (NVS) on the device. The content of the permanent log is
retained over a reboot. Once the permanent log reaches its configured maximum
allowable size old messages will be deleted to make way for new messages.
The no variant of this command configures the device not to send any messages
to the permanent log. Log messages will not be retained over a restart.
Syntax
log permanent
no log permanent
Mode Global Configuration
Examples To enable permanent logging use the following commands:
awplus# configure terminal
awplus(config)# log permanent
To disable permanent logging use the following commands:
awplus# configure terminal
awplus(config)# no log permanent
Related
Commands
clear log permanent
default log permanent
log permanent (filter)
log permanent exclude
log permanent size
show log config
show log permanent
To Next Page
Loading...
Need help?
General
