C613-50100-01 REV C Command Reference for x930 Series 600
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
SPANNING TREE COMMANDS
SPANNING
-TREE CISCO-INTEROPERABILITY (MSTP)
spanning-tree cisco-interoperability (MSTP)
Overview Use this command to enable/disable Cisco-interoperability for MSTP.
Use this command for MSTP only.
Syntax
spanning-tree cisco-interoperability {enable|disable}
Default If this command is not used, Cisco interoperability is disabled.
Mode Global Configuration
Usage For compatibility with certain Cisco devices, all devices in the switched LAN
running the AlliedWare Plus™ Operating System must have Cisco-interoperability
enabled. When the AlliedWare Plus Operating System is interoperating with Cisco,
the only criteria used to classify a region are the region name and revision level.
VLAN to instance mapping is not used to classify regions when interoperating with
Cisco.
Examples To enable Cisco interoperability on a Layer 2 device:
awplus# configure terminal
awplus(config)# spanning-tree cisco-interoperability enable
To disable Cisco interoperability on a Layer 2 device:
awplus# configure terminal
awplus(config)# spanning-tree cisco-interoperability disable
Parameter Description
enable Enable Cisco interoperability for MSTP.
disable Disable Cisco interoperability for MSTP.
To Next Page
Loading...
Need help?
General
