C613-50100-01 REV C Command Reference for x930 Series 2744
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
DYNAMIC HOST CONFIGURATION PROTOCOL (DHCP) COMMANDS
SHOW
IP DHCP POOL
show ip dhcp pool
Overview This command displays the configuration details and system usage of the DHCP
address pools configured on the device.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show ip dhcp pool [<address-pool>]
Mode User Exec and Privileged Exec
Example
awplus# show ip dhcp pool
Output Figure 55-7: Example output from the show ip dhcp pool command
Parameter Description
<address-pool> Name of a specific address pool. This displays the
configuration of the specified address pool only.
Pool p1 :
network: 192.168.1.0/24
address ranges:
addr: 192.168.1.10 to 192.168.1.18
static host addresses:
addr: 192.168.1.12 MAC addr: 1111.2222.3333
lease <days:hours:minutes:seconds> <1:0:0:0>
subnet mask: 255.255.255.0 (pool's network mask)
Probe: Default Values
Status: Enabled [Enabled]
Type: ARP [Ping]
Packets: 2 [5]
Timeout: 200 msecs [200]
Dynamic addresses:
Total: 8
Leased: 2
Utilization: 25.0 %
Static host addresses:
Total: 1
Leased: 1
To Next Page
Loading...
Need help?
General
