24
C613-50100-01 REV C Command Reference for x930 Series 860
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
RIP Commands
Introduction
Overview This chapter provides an alphabetical reference of commands used to configure
RIP.
For information about configuring RIP, see the RIP Feature Overview and
Configuration Guide.
Command List •“accept-lifetime” on page 862
•“address-family ipv4 (RIP)” on page 864
•“alliedware-behavior” on page 865
•“cisco-metric-behavior (RIP)” on page 867
•“clear ip rip route” on page 868
•“debug rip” on page 869
•“default-information originate (RIP)” on page 870
•“default-metric (RIP)” on page 871
•“distance (RIP)” on page 872
•“distribute-list (RIP)” on page 874
•“fullupdate (RIP)” on page 876
•“ip rip authentication key-chain” on page 877
•“ip rip authentication mode” on page 879
•“ip rip authentication string” on page 882
•“ip rip receive-packet” on page 884
•“ip rip receive version” on page 885
•“ip rip send-packet” on page 886
•“ip rip send version” on page 887
To Next Page
Loading...
Need help?
General
