C613-50100-01 REV C Command Reference for x930 Series 2806
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
NTP COMMANDS
NTP
AUTHENTICATE
ntp authenticate
Overview This command enables NTP authentication. This allows NTP to authenticate the
associations with other systems for security purposes.
The no variant of this command disables NTP authentication.
Syntax
ntp authenticate
no ntp authenticate
Mode Global Configuration
Examples To enable NTP authentication, use the commands:
awplus# configure terminal
awplus(config)# ntp authenticate
To disable NTP authentication, use the commands:
awplus# configure terminal
awplus(config)# no ntp authenticate
To Next Page
Loading...
