C613-50100-01 REV C Command Reference for x930 Series 245
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
SYSTEM CONFIGURATION AND MONITORING COMMANDS
ECOFRIENDLY
LED
ecofriendly led
Overview Use this command to enable the eco-friendly LED (Light Emitting Diode) feature,
which turns off power to the port LEDs, including the stack port status LEDs. Power
to the system status and stack management LEDs is not disabled.
Use the no variant of this command to disable the eco-friendly LED feature.
Syntax
ecofriendly led
no ecofriendly led
Default The eco-friendly LED feature is disabled by default.
Mode Global Configuration
Usage When the eco-friendly LED feature is enabled, a change in port status will not affect
the display of the associated LED. When the eco-friendly LED feature is disabled
and power is returned to port LEDs, the LEDs will correctly show the current state
of the ports.
In a stacked environment, enabling the eco-friendly LED feature on the stack
master will apply the feature to every member of the stack.
For an example of how to configure a trigger to turn off power to port LEDs, see the
Triggers Feature Overview and Configuration Guide.
Examples To enable the eco-friendly LED feature which turns off power to all port LEDs, use
the following commands:
awplus# configure terminal
awplus(config)# ecofriendly led
To disable the eco-friendly LED feature, use the following command:
awplus# configure terminal
awplus(config)# no ecofriendly led
Related
Commands
ecofriendly lpi
show ecofriendly
To Next Page
Loading...
Need help?
General
