C613-50100-01 REV C Command Reference for x930 Series 2154
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
AUTHENTICATION COMMANDS
AUTH
-WEB-SERVER BLOCKING-MODE
auth-web-server blocking-mode
Overview Use this command to enable blocking mode for the Web-Authentication server.
The blocking mode displays an authentication success or failure screen
immediately from the response result from a RADIUS server.
Use the no variant of this command to disable blocking mode for the
Web-Authentication server.
Syntax
auth-web-server blocking-mode
no auth-web-server blocking-mode
Default By default, blocking mode is disabled for the Web-Authentication server.
Mode Global Configuration
Example To enable blocking mode for the Web-Authentication server, use the following
commands:
awplus# configure terminal
awplus(config)# auth-web-server blocking-mode
To disable blocking mode for the Web-Authentication server, use the following
commands:
awplus# configure terminal
awplus(config)# no auth-web-server blocking-mode
Related
Commands
auth-web-server redirect-delay-time
show auth-web-server
show running-config
To Next Page
Loading...
Need help?
General
