C613-50100-01 REV C Command Reference for x930 Series 3006
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
TRIGGER COMMANDS
REPEAT
repeat
Overview This command specifies the number of times that a trigger is permitted to activate.
This allows you to specify whether you want the trigger to activate:
• only the first time that the trigger conditions are met
• a limited number of times that the trigger conditions are met
• an unlimited number of times
Once the trigger has reached the limit set with this command, the trigger remains
in your configuration but cannot be activated. Use the repeat command again to
reset the trigger so that it is activated when its trigger conditions are met.
By default, triggers can activate an unlimited number of times. To reset a trigger to
this default, specify either yes or forever.
Syntax
repeat {forever|no|once|yes|<1-4294967294>}
Mode Trigger Configuration
Examples To allow trigger 21 to activate only once, use the commands:
awplus# configure terminal
awplus(config)# trigger 21
awplus(config-trigger)# repeat no
To allow trigger 22 to activate an unlimited number of times whenever its trigger
conditions are met, use the commands:
awplus# configure terminal
awplus(config)# trigger 22
awplus(config-trigger)# repeat forever
To allow trigger 23 to activate only the first 10 times the conditions are met, use
the commands:
awplus# configure terminal
awplus(config)# trigger 23
awplus(config-trigger)# repeat 10
Related
Commands
show trigger
trigger
Parameter Description
yes|forever The trigger repeats indefinitely, or until disabled.
no|once The trigger activates only once.
<1-4292967294> The trigger repeats the specified number of times.
To Next Page
Loading...
Need help?
General
