C613-50100-01 REV C Command Reference for x930 Series 2578
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ALLIED TELESIS MANAGEMENT FRAMEWORK™ (AMF) COMMANDS
ATMF
PROVISION
atmf provision
Overview This command configures a specified port on an AMF node to accept a provisioned
node, via an AMF link, some time in the future.
Use the no variant of this command to remove the provisioning on the node.
Syntax
atmf provision [<nodename>]
no atmf provision
Default No AMF provisioning.
Mode Interface Configuration for a switchport, a static aggregator or a dynamic channel
group.
Usage The port should be configured as an AMF link or cross link and should be “down”
to add or remove a provisioned node.
Example To provision an AMF node named node1 for port1.0.1, use the command:
host1(config)# interface port1.0.1
host1(config-if)# atmf provision node1
Related
Commands
switchport atmf-link
switchport atmf-crosslink
show atmf links
Parameter Description
<nodename> The name of the provisioned node that will appear on
the AMF network in the future.
To Next Page
Loading...
