C613-50100-01 REV C Command Reference for x930 Series 1862
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IPV4 HARDWARE ACCESS CONTROL LIST (ACL) COMMANDS
ACCESS
-LIST (HARDWARE IP NUMBERED)
access-list (hardware IP numbered)
Overview This command creates an access-list for use with hardware classification, such as
QoS. The access-list will match on either TCP or UDP type packets that have the
specified source and destination IP addresses and Layer 4 port values or ranges.
The parameter any may be specified if an address does not matter and the port
values are optional.
The no variant of this command removes the previously specified IP hardware
access-list.
Syntax [ip]
access-list <3000-3699>
{deny|permit|copy-to-cpu|copy-to-mirror|send-to-mirror|
send-to-cpu} ip <source> <destination> [vlan
<1-4094>]
Syntax [icmp] access-list <3000-3699>
{deny|permit|copy-to-cpu|copy-to-mirror|send-to-mirror|
send-to-cpu} icmp <source> <destination>
[icmp-type <type-number>]
no access-list <3000-3699>
Table 38: Parameters in the access-list (hardware IP numbered) command -
ip|icmp
Parameter Description
<3000-3699> Hardware IP access-list number.
deny Access-list rejects packets that match the source and destination
filtering specified with this command.
permit Access-list permits packets that match the source and
destination filtering specified with this command.
copy-to-cpu Specify packets to copy to the CPU.
copy-to-mirror Specify packets to copy to the mirror port.
send-to-mirror Specify packets to send to the mirror port.
send-to-cpu Specify packets to send to the CPU.
icmp ICMP packet.
ip IP packet.