Allied Telesis AlliedWare Plus - Show Platform

C613-50100-01 REV C Command Reference for x930 Series 490
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
SWITCHING COMMANDS
SHOW
PLATFORM
show platform
Overview This command displays the settings configured by using the platform commands.
Syntax
show platform
Mode Privileged Exec
Usage This command displays the settings in the running config. For changes in some of
these settings to take effect, the device must be rebooted with the new settings in
the startup config.
Example To check the settings configured with platform commands on the device, use the
following command:
awplus# show platform
Output Figure 14-7: Example output from the show platform command
awplus# show platform

MAC vlan hashing algorithm crc32l
L3 hashing algorithm crc32l
Port mode
port1.1.1 40g 
port1.1.5 40g 
port2.1.1 40g 
port2.1.5 40g 
Vlan-stacking TPID 0x8100
Hardware Filter Size ipv4-full-ipv6
Table 5: Parameters in the output of the show platform command
Parameter Description
MAC vlan hashing
algorithm
The MAC VLAN hash-key-generating algorithm (set with
the platform mac-vlan-hashing-algorithm command). The
default algorithm is crc32l. The algorithm may need to be
changed in rare circumstances in which hash collisions
occur.
L3 hashing algorithm The L3 VLAN hash-key-generating algorithm (set with the
platform l3-vlan-hashing-algorithm command). The
default algorithm is crc32l. The algorithm may need to be
changed in rare circumstances in which hash collisions
occur.
stop-unreg-mc-flooding Whether the stop-unreg-mc-flooding feature is on or off
(set with the platform stop-unreg-mc-flooding
command). This feature prevents flooding of unregistered
multicast packets in the occasional situations in which
IGMP snooping does not prevent it.