Allied Telesis AlliedWare Plus - Atmf Log-Verbose

C613-50100-01 REV C Command Reference for x930 Series 2571
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ALLIED TELESIS MANAGEMENT FRAMEWORK™ (AMF) COMMANDS
ATMF
LOG-VERBOSE
atmf log-verbose
Overview This command limits the number of log messages displayed on the console or
permanently logged.
Syntax
atmf log-verbose <1-3>
no atmf log-verbose
Default The default log display is 3.
Usage This command is intended for use in large networks where verbose output can
make the console unusable for periods of time while nodes are joining and leaving.
Mode Global Configuration
Example To set the log-verbose to noise level 2, use the command:
node-1# configure terminal
node-1(config)# atmf log-verbose 2
Validation
Command
show atmf
Parameter Description
<1-3> The verbose limitation (3 = noisiest, 1 = quietest)