C613-50100-01 REV C Command Reference for x930 Series 2946
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
RMON COMMANDS
SHOW
RMON HISTORY
show rmon history
Overview Use this command to display the parameters specified on all the currently defined
RMON history collections on the device.
NOTE: Only the history for switch port interfaces, not for VLAN interfaces, can be
shown.
Syntax
show rmon history
Mode User Exec and Privileged Exec
Output Figure 61-2: Example output from the show rmon history command
NOTE: The following etherStats counters are not currently available for Layer 3
interfaces:
• etherStatsBroadcastPkts
• etherStatsCRCAlignErrors
• etherStatsUndersizePkts
•etherStatsOversizePkts
• etherStatsFragments
• etherStatsJabbers
• etherStatsCollisions
• etherStatsPkts64Octets
• etherStatsPkts65to127Octets
• etherStatsPkts128to255Octets
• etherStatsPkts256to511Octets
• etherStatsPkts512to1023Octets
awplus#sh rmon history
history index = 56
data source ifindex = 4501
buckets requested = 34
buckets granted = 34
Interval = 2000
Owner Andrew
history index = 458
data source ifindex = 5004
buckets requested = 400
buckets granted = 400
Interval = 1500
Owner trev
========================================================
To Next Page
Loading...
