C613-50100-01 REV C Command Reference for x930 Series 2335
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PUBLIC KEY INFRASTRUCTURE COMMANDS
CRYPTO
PKI TRUSTPOINT
crypto pki trustpoint
Overview Use this command to declare the named trustpoint and enter trustpoint
configuration mode.
Use the no variant of this command to destroy the trustpoint.
Syntax
crypto pki trustpoint <trustpoint>
no crypto pki trustpoint <trustpoint>
Mode Global Configuration
Usage If the trustpoint did not previously exist, it is created as a new trustpoint. The
trustpoint will be empty (unauthenticated) unless the name “local” is selected, in
which case the system will automatically authenticate the trustpoint as a local
self-signed certificate authority.
The no variant of this command destroys the trustpoint by removing all CA and
server certificates associated with the trustpoint, as well as the private key
associated with the root certificate (if the root certificate was locally self-signed).
This is a destructive and irreversible operation, so this command should be used
with caution.
Example To configure a trustpoint named “example”, use the following commands:
awplus> enable
awplus# configure terminal
awplus(config)# crypto pki trustpoint example
Related
Commands
show crypto pki certificates
show crypto pki trustpoint
Parameter Description
<trustpoint> The name of the trustpoint. The name must start with an
alphanumeric character, and may only contain alphanumeric
characters, underscores, dashes, or periods. The maximum length
of the name is 63 characters.
To Next Page
Loading...
Need help?
General
