C613-50100-01 REV C Command Reference for x930 Series 2952
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
SECURE SHELL (SSH) COMMANDS
BANNER
LOGIN (SSH)
banner login (SSH)
Overview This command configures a login banner on the SSH server. This displays a
message on the remote terminal of the SSH client before the login prompt. SSH
client version 1 does not support this banner.
To add a banner, first enter the command banner login, and hit [Enter]. Write your
message. You can use any character and spaces. Use Ctrl+D at the end of your
message to save the text and re-enter the normal command line mode.
The banner message is preserved if the device restarts.
The no variant of this command deletes the login banner from the device.
Syntax
banner login
no banner login
Default No banner is defined by default.
Mode Global Configuration
Examples To set a login banner message, use the commands:
awplus# configure terminal
awplus(config)# banner login
The screen will prompt you to enter the message:
Type CNTL/D to finish.
... banner message comes here ...
Enter the message. Use Ctrl+D to finish, like this:
^D
awplus(config)#
To remove the login banner message, use the commands:
awplus# configure terminal
awplus(config)# no banner login
Related
Commands
show banner login
To Next Page
Loading...
Need help?
General
