C613-50100-01 REV C Command Reference for x930 Series 996
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
OSPF COMMANDS
IP
OSPF NETWORK
ip ospf network
Overview This command configures the OSPF network type to a type different from the
default for the particular VLAN interface.
The no variant of this command returns the network type to the default for the
particular VLAN interface.
Syntax
ip ospf network [broadcast|non-broadcast|point-to-point|
point-to-multipoint]
no ip ospf network
Default The default is the broadcast OSPF network type for a VLAN interface.
Mode Interface Configuration for a VLAN interface.
Usage This command forces the interface network type to the specified type. Depending
on the network type, OSPF changes the behavior of the packet transmission and
the link description in LSAs.
Example The following example shows setting the network type to point-to-point on the
VLAN interface vlan2.
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ip ospf network point-to-point
Parameter Description
broadcast Sets the network type to broadcast.
non-broadcast Sets the network type to NBMA.
point-to-multipoint Sets the network type to point-to-multipoint.
point-to-point Sets the network type to point-to-point.
To Next Page
Loading...
Need help?
General
