Allied Telesis AlliedWare Plus - Stack Virtual-Chassis-ID

C613-50100-01 REV C Command Reference for x930 Series 2459
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
VIRTUAL CHASSIS STACKING (VCSTACK™) COMMANDS
STACK
VIRTUAL-CHASSIS-ID
stack virtual-chassis-id
Overview This command specifies the stack virtual chassis ID. The ID selected will determine
which virtual MAC address the stack will use. The MAC address assigned to a stack
must be unique within its network.
NOTE: The command will not take effect until the switch has been rebooted.
Syntax
stack virtual-chassis-id <id>
Mode Global Configuration
Usage The virtual-chassis-id entered will form the last 12 bits of a pre-selected MAC prefix
component; that is, 0000.cd37.0xxx. If you enable the stack virtual MAC address
feature (by using the stack virtual-mac command) without using the stack virtual-
chassis-id command to select the virtual-chassis-id, then the stack will select a
virtual- chassis-id from a number within the assigned range.
Example To set the stack virtual-chassis-id to 63 use the commands
awplus# configure terminal
awplus(config)# stack virtual-chassis-id 63
This will result in a virtual MAC address of: 0000.cd37.003f.
Related
Commands
show running-config
show stack
switch provision (stack)
stack virtual-mac
Parameter Description
<id> The value of the ID - enter a number in the range 0 to 4095.