C613-50100-01 REV C Command Reference for x930 Series 1021
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
OSPF COMMANDS
SHOW
IP OSPF
show ip ospf
Overview Use this command to display general information about all OSPF routing
processes. Include the process ID parameter with this command to display
information about specified instances.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show ip ospf
show ip ospf <process-id>
Mode User Exec and Privileged Exec
Examples To display general information about all OSPF routing processes, use the
command:
awplus# show ip ospf
To display general information about OSPF routing process 100, use the
command:
awplus# show ip ospf 100
Parameter Description
<process-id> <0-65535> The ID of the router process for which information will
be displayed. If this parameter is included, only the information for
the specified routing process is displayed.
Table 1: Example output from the show ip ospf command
Route Licence: Route : Limit=0, Allocated=0, Visible=0, Internal=0
Route Licence: Breach: Current=0, Watermark=0
Routing Process "ospf 10" with ID 192.168.1.1
Process uptime is 10 hours 24 minutes
Process bound to VRF default
Conforms to RFC2328, and RFC1583 Compatibility flag is disabled
Supports only single TOS(TOS0) routes
Supports opaque LSA
Supports Graceful Restart
SPF schedule delay min 0.500 secs, SPF schedule delay max 50.0 secs
Refresh timer 10 secs
Number of incomming current DD exchange neighbors 0/5
Number of outgoing current DD exchange neighbors 0/5
Number of external LSA 0. Checksum 0x000000
Number of opaque AS LSA 0. Checksum 0x000000
Number of non-default external LSA 0
To Next Page
Loading...
Need help?
General
