C613-50100-01 REV C Command Reference for x930 Series 291
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
SYSTEM CONFIGURATION AND MONITORING COMMANDS
SHOW
SYSTEM INTERRUPTS
show system interrupts
Overview Use this command to display the number of interrupts for each IRQ (Interrupt
Request) used to interrupt input lines on a PIC (Programmable Interrupt Controller)
on your device.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show system interrupts
Mode User Exec and Privileged Exec
Example To display information about the number of interrupts for each IRQ in your device,
use the command:
awplus# show system interrupts
Output Figure 7-20: Example output from the show system interrupts command
Related
Commands
show system environment
awplus>show system interrupts
CPU0
1: 2 CPM2 SIU Level Enabled 0 i2c-mpc
2: 145 CPM2 SIU Level Enabled 0 spi-mpc
77: 0 OpenPIC Level Enabled 0 enet_tx
78: 2 OpenPIC Level Enabled 0 enet_rx
82: 0 OpenPIC Level Enabled 0 enet_error
90: 5849 OpenPIC Level Enabled 0 serial
91: 2066672 OpenPIC Level Enabled 0 i2c-mpc
94: 147 OpenPIC Level Enabled 0 cpm2_cascade
112: 5 OpenPIC Edge Enabled 0 phy_interrupt
114: 398714 OpenPIC Level Enabled 0 mvPP
115: 26247 OpenPIC Level Enabled 0 mvPP
119: 0 OpenPIC Edge Enabled 0 Power supply status
...
BAD: 0
To Next Page
Loading...
Need help?
General
