Allied Telesis AlliedWare Plus - Type Stack Master-Fail

C613-50100-01 REV C Command Reference for x930 Series 3033
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
TRIGGER COMMANDS
TYPE
STACK MASTER-FAIL
type stack master-fail
Overview This command (configured to the stack) initiates the action of a pre-configured
trigger to occur when the stack enters the fail-over state.
Syntax
type stack master-fail
Mode Trigger Configuration
Example To configure trigger 86 to activate when stack master fail-over event occurs, use
the commands:
awplus# configure terminal
awplus(config)# trigger 86
awplus(config-trigger)# type stack master-fail
Related
Commands
stack disabled-master-monitoring
trigger
type stack disabled-master
type stack member
type stack link