C613-50100-01 REV C Command Reference for x930 Series 1947
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IPV6 HARDWARE ACCESS CONTROL LIST (ACL) COMMANDS
(IPV6 ACCESS-LIST NAMED ICMP FILTER)
(ipv6 access-list named ICMP filter)
Overview Use this ACL filter to add a filter entry for an IPv6 source and destination address
and prefix, with ICMP (Internet Control Message Protocol) packets, to the current
named IPv6 access-list.
If you specify a sequence number, the new entry is inserted at the specified
location. Otherwise, the new entry is added at the end of the access-list.
Note that specifying the send-to-cpu parameter could result in EPSR healthcheck
messages and other control packets being dropped.
As an optional parameter, vlan can be matched for tagged (802.1q) packets.
The no variant of this command removes a filter entry for an IPv6 source and
destination address and prefix, with ICMP (Internet Control Message Protocol)
packets, from the current named IPv6 access-list. You can specify the filter entry for
removal by entering either its sequence number, or its filter entry profile.
NOTE: Hardware ACLs will permit access unless explicitly denied by an ACL action.
Syntax
[<sequence-number>
{deny|permit|send-to-cpu|send-to-mirror|copy-to-cpu|
copy-to-mirror} icmp
{<ipv6-source-address/prefix-length>|
<ipv6-source-address> <ipv6-source-wildcard>|
host <ipv6-source-host>|any}
{<ipv6-destination-address/prefix-length>|
<ipv6-destination-addr> <ipv6-destination-wildcard>|
host <ipv6-destination-host-address>|any}
[<icmp-type>] [vlan <1-4094>]
no [<sequence-number>]
{deny|permit|send-to-cpu|send-to-mirror|copy-to-cpu|
copy-to-mirror} icmp
{<ipv6-source-address/prefix-length>|
<ipv6-source-address> <ipv6-source-wildcard>|
host <ipv6-source-host>|any}
{<ipv6-destination-address/prefix-length>|
<ipv6-destination-address> <ipv6-destination-wildcard>|
host <ipv6-destination-host-address>|any}
[<icmp-type>] [vlan <1-4094>]
no [<sequence-number>]
Parameter Description
<sequence-number> The sequence number for the filter entry of the
selected access control list, from 1 to 65535.
deny Specifies the packets to reject.
permit Specifies the packets to permit.
To Next Page
Loading...
