EasyManuals Logo

Allied Telesis AlliedWare Plus User Manual

Allied Telesis AlliedWare Plus
3082 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1948 background imageLoading...
Page #1948 background image
C613-50100-01 REV C Command Reference for x930 Series 1948
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IPV6 HARDWARE ACCESS CONTROL LIST (ACL) COMMANDS
(IPV6 ACCESS-LIST NAMED ICMP FILTER)
Mode IPv6 Hardware ACL Configuration
send-to-cpu Specifies the packets to send to the CPU.
Specifying this parameter could result in EPSR
healthcheck messages and other control
packets being dropped.
send-to-mirror Specifies the packets to send to mirror port.
copy-to-cpu Specifies the packets to copy to the CPU.
copy-to-mirror Specifies the packets to copy to the mirror port.
icmp ICMP packet, defined by the following
parameters.
<ipv6-source-address/
prefix-length>
Specifies a source address and prefix length.
The IPv6 address prefix uses the format
X:X::/prefix-length. The prefix-length is usually
set between 0 and 64.
<ipv6-source-address> Specifies the IPv6 source address.
The IPv6 address uses the format X:X::X:X.
<ipv6-source-wildcard> Specifies source wildcard bits in IPv6 format
X:X::X:X.
Note that binary 1 represents a don’t care
condition, and binary 0 represents a match.
host <ipv6-source-host> Specifies a single source host address.
The IPv6 address uses the format X:X::X:X.
any Specifies any Source host.
<ipv6-destination-
address/prefix-length>
Specifies a destination address and prefix
length.
The IPv6 address uses the format
X:X::X:X/Prefix-Length. The prefix-length is
usually set between 0 and 64.
<ipv6-destination-
address>
Specifies a destination address.
The IPv6 address uses the format X:X::X:X.
<ipv6-destination-
wildcard>
Specify destination wildcard bits in IPv6 format
X:X::X:X.
host <ipv6-destination-
host-address>
Specify a single destination host address.
The IPv6 address uses the format X:X::X:X.
any Specifies any destination host.
<icmp-type> Optional. Specify to filter by ICMP message type
number. Valid values are from 0 to 255.
vlan Specifies that the ACL will match on the ID in
the packet's VLAN tag. This parameter can be
used in either single or double-tagged VLAN
networks. It is the conventional VLAN tag (VID).
<1-4094> The VLAN VID.
Parameter Description

Table of Contents

Other manuals for Allied Telesis AlliedWare Plus

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allied Telesis AlliedWare Plus and is the answer not in the manual?

Allied Telesis AlliedWare Plus Specifications

General IconGeneral
BrandAllied Telesis
ModelAlliedWare Plus
CategorySwitch
LanguageEnglish

Related product manuals