C613-50100-01 REV C Command Reference for x930 Series 1577
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
VRF LITE COMMANDS
SSH
ssh
Overview This command initiates a Secure Shell connection to a remote SSH server.
If the server requests a password for the user login, the user needs to type in the
correct password on “Password:” prompt.
SSH client identifies the remote SSH server by its public key registered on the client
device. If the server identification is changed, server verification fails. If the public
key of the server has been changed, the public key of the server must be explicitly
added to the known host database.
NOTE: Note that a hostname specified with SSH cannot begin with a hyphen (-)
character.
Syntax
ssh [ip|ipv6][{[user <username>]|[port <1-65535>]|[version
{1|2]}}] <hostname> [<line>]
Syntax (VRF lite) ssh [vrf <vrf-name>] [ip|ipv6][{[user <username>]|[port
<1-65535>]|[version {1|2]}}] <hostname> [<line>]
Parameter Description
vrf Apply the command to the specified VRF instance.
<vrf-name> The name of the VRF instance.
ip Specify IPv4 SSH.
ipv6 Specify IPv6 SSH.
user Login user. If user is specified, the username is used for login to the
remote SSH server when user authentication is required. Otherwise
the current user name is used.
<username> User name to login on the remote server.
port SSH server port. If port is specified, the SSH client connects to the
remote SSH server with the specified TCP port. Other- wise, the
client port configured by “ssh client” command or the default TCP
port (22) is used.
<1-65535> TCP port.
version SSH client version. If version is specified, the SSH client supports
only the specified SSH version. By default, SSH client uses SSHv2
first. If the server does not support SSHv2, it will try SSHv1. The
default version can be configured by “ssh client” command.
1 Use SSH version 1.
2 Use SSH version 2.
To Next Page
Loading...
Need help?
General
