39
C613-50100-01 REV C Command Reference for x930 Series 1942
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IPv6 Hardware
Access Control List
(ACL) Commands
Introduction
Overview This chapter provides an alphabetical reference for the IPv6 Hardware Access
Control List (ACL) commands, and contains detailed command information and
command examples about IPv6 hardware ACLs, which are applied directly to
interfaces using the ipv6 traffic-filter command.
For information about ACLs, see the ACL Feature Overview and Configuration
Guide.
To apply ACLs to an LACP channel group, apply it to all the individual switch ports
in the channel group. To apply ACLs to a static channel group, apply it to the static
channel group itself. For more information on link aggregation see the following
references:
•the Link Aggregation Feature Overview_and Configuration Guide.
• Link Aggregation Commands
Note that text in parenthesis in command names indicates usage not keyword
entry. For example, ipv6-access-list (named) indicates named IPv6 ACLs entered
as ipv6-access-list <name> where <name> is a placeholder not a keyword.
Note also that parenthesis surrounding ACL filters indicates the type of ACL filter,
not the keyword entry in the CLI. For example (ipv6 access-list standard IPv6
filter) represents command entry in the format shown in the syntax
[<sequence-number>] {deny|permit} {<IPv6-source-address/prefix-length>|any}.
Hardware ACLs will permit access unless explicitly denied by an ACL action.
Sub-modes Many of the ACL commands operate from sub-modes that are specific to particular
ACL types. The following table shows the CLI prompts at which ACL commands are
entered.
To Next Page
Loading...
Need help?
General
