Allied Telesis AlliedWare Plus - Ip Pim Spt-Threshold

C613-50100-01 REV C Command Reference for x930 Series 1745
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PIM-SM COMMANDS
IP
PIM SPT-THRESHOLD
ip pim spt-threshold
Overview This command turns on the ability for the last-hop PIM router to switch to SPT
(shortest-path tree).
The no variant of this command turns off the ability for the last-hop PIM router to
switch to SPT.
NOTE: The switching to SPT happens either at the receiving of the first data packet, or
not at all; it is not rate-based.
Syntax
ip pim spt-threshold
no ip pim spt-threshold
Mode Global Configuration
Examples To enable the last-hop PIM-SM router to switch to SPT, use the following
commands:
awplus# configure terminal
awplus(config)# ip pim spt-threshold
To stop the last-hop PIM-SM router from being able to switch to SPT, use the
following commands:
awplus# configure terminal
awplus(config)# no ip pim spt-threshold
Related
Commands
ip pim spt-threshold group-list