C613-50100-01 REV C Command Reference for x930 Series 912
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
RIP COMMANDS
SHOW
IP PROTOCOLS RIP
show ip protocols rip
Overview Use this command to display RIP process parameters and statistics.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show ip protocols rip
Mode User Exec and Privileged Exec
Example
awplus# show ip protocols rip
Output Figure 24-1: Example output from the show ip protocols rip command
Routing Protocol is "rip"
Sending updates every 30 seconds with +/-50%, next due in 12
seconds
Timeout after 180 seconds, garbage collect after 120 seconds
Outgoing update filter list for all interface is not set
Incoming update filter list for all interface is not set
Default redistribution metric is 1
Redistributing: connected static
Default version control: send version 2, receive version 2
Interface Send Recv Key-chain
vlan25 2 2
Routing for Networks:
10.10.0.0/24
Routing Information Sources:
Gateway BadPackets BadRoutes Distance Last Update
Distance: (default is 120
To Next Page
Loading...
Need help?
General
