Allied Telesis AlliedWare Plus - Auth-Mac Accounting

C613-50100-01 REV C Command Reference for x930 Series 2135
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
AUTHENTICATION COMMANDS
AUTH
-MAC ACCOUNTING
auth-mac accounting
Overview This command overrides the default RADIUS accounting method for MAC-based
authentication on an interface by allowing you to apply a user-defined named list.
Use the no variant of this command to remove the named list from the interface
and apply the default method.
Syntax
auth-mac accounting {default|<list-name>}
no auth-mac accounting
Default The default method list is applied to an interface by default.
Mode Interface Mode
Example To apply the named list 'vlan10_acct' on the vlan10 interface, use the commands:
awplus# configure terminal
awplus(config)# interface vlan10
awplus(config-if)# auth-mac accounting vlan10_acct
To remove the named list from the vlan10 interface and set the accounting
method back to default, use the commands:
awplus# configure terminal
awplus(config)# interface vlan10
awplus(config-if)# no auth-mac accounting
Related
Commands
aaa accounting auth-mac
Parameter Description
default Apply the default accounting method list
<list-name> Apply the user-defined named list