C613-50100-01 REV C Command Reference for x930 Series 2160
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
AUTHENTICATION COMMANDS
AUTH
-WEB-SERVER IPADDRESS
auth-web-server ipaddress
Overview This command sets the IP address for the Web-Authentication server.
Use the no variant of this command to delete the IP address for the
Web-Authentication server.
You cannot use the IPv4 address assigned to the device’s interface as the
Web-Authentication server address.
Syntax
auth-web-server ipaddress <ip-address>
no auth-web-server ipaddress
Default The Web-Authentication server address on the system is not set by default.
Mode Global Configuration
Examples To set the IP address 10.0.0.1 to the Web-Authentication server, use the
following commands:
awplus# configure terminal
awplus(config)# auth-web-server ipaddress 10.0.0.1
To delete the IP address from the Web-Authentication server, use the following
commands:
awplus# configure terminal
awplus(config)# no auth-web-server ipaddress
Validation
Commands
show auth
show auth-web-server
show running-config
Parameter Description
<ip-address> Web-Authentication server dotted decimal IP address in
A.B.C.D format.
To Next Page
Loading...
Need help?
General
