C613-50100-01 REV C Command Reference for x930 Series 1887
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IPV4 HARDWARE ACCESS CONTROL LIST (ACL) COMMANDS
(ACCESS-LIST HARDWARE TCP UDP FILTER)
(access-list hardware TCP UDP filter)
Overview Use this ACL filter to add a TCP or UDP filter entry to the current hardware
access-list. The filter will match on any TCP or UDP type packet that has the
specified source and destination IP addresses. The parameter any may be specified
if an address does not matter. If a sequence number is specified, the new filter is
inserted at the specified location. Otherwise, the new filter is added at the end of
the access-list.
The no variant of this command removes a TCP or UDP filter entry from the current
hardware access-list. You can specify the TCP or UDP filter entry for removal by
entering either its sequence number (e.g. no 10), or by entering its TCP or UDP
filter profile without specifying its sequence number.
Note that the sequence number can be found by running the show access-list (IPv4
Hardware ACLs) command.
Syntax [tcp|udp]
[<sequence-number>]
{deny|permit|send-to-cpu|copy-to-cpu|copy-to-mirror} {tcp|udp}
[<source> {eq <sourceport>|gt <sourceport>|lt <sourceport>|
ne <sourceport>|range <start-range> <end-range>}]
[<destination> {eq <destport>|gt <destport>|lt <destport>|
ne <destport>|range <start-range> <end-range>}]
no {deny|permit|send-to-cpu|copy-to-cpu|copy-to-mirror}
{tcp|udp} [<source>
{eq <sourceport>|gt <sourceport>|lt <sourceport>|
ne <sourceport>|range <start-range> <end-range>}]
[<destination> {eq <destport>|gt <destport>|lt <destport>|
ne <destport>|range <start-range> <end-range>}]
no <sequence-number>
Parameter Description
<sequence-number> <1-65535>
The sequence number for the filter entry of the
selected access control list.
deny Access-list rejects packets that match the source and
destination filtering specified with this command.
permit Access-list permits packets that match the source and
destination filtering specified with this command.
send-to-cpu Specify packets to send to the CPU.
copy-to-cpu Specify packets to copy to the CPU.
copy-to-mirror Specify packets to copy to the mirror port.
tcp TCP packets.
udp UDP packets.
To Next Page
Loading...
Need help?
General
