C613-50100-01 REV C Command Reference for x930 Series 1888
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IPV4 HARDWARE ACCESS CONTROL LIST (ACL) COMMANDS
(ACCESS-LIST HARDWARE TCP UDP FILTER)
<source> The source address of the packets. You can specify a
single host, a subnet, or all sources. The following are
the valid formats for specifying the source:
any Matches any source IP address.
host<ip-addr> Matches a single source host
with the IP address given by
<ip-addr> in dotted decimal
notation.
<ip-addr>/
<prefix>
An IPv4 address, followed by a
forward slash, then the prefix
length. This matches any source
IP address within the specified
subnet.
<ip-addr>
<reverse-mask>
Alternatively, you can enter a
reverse mask in dotted decimal
format. For example, entering
192.168.1.1 0.0.0.255
is the same as entering
192.168.1.1/24.
<sourceport> The source TCP or UDP port number, specified as an
integer between 0 and 65535.
<destination> The destination address of the packets. You can specify
a single host, a subnet, or all destinations. The
following are the valid formats for specifying the
destination:
any Matches any destination IP
address.
host<ip-addr> Matches a single destination
host with the IP address given
by <ip-addr> in dotted decimal
notation.
<ip-addr>/
<prefix>
An IPv4 address, followed by a
forward slash, then the prefix
length. This matches any
destination IP address within
the specified subnet.
<ip-addr>
<reverse-mask>
Alternatively, you can enter a
reverse mask in dotted decimal
format. For example, entering
192.168.1.1 0.0.0.255
is the same as entering
192.168.1.1/24.
eq Equal to.
lt Less than.
gt Greater than.
ne Not equal to.
Parameter Description
To Next Page
Loading...
