Allied Telesis AlliedWare Plus - Chapter 65: Sflow Commands; Introduction; Sflow Commands

65
C613-50100-01 REV C Command Reference for x930 Series 3063
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
sFlow Commands
Introduction
Overview This chapter provides an alphabetical reference for sFlow commands.
Command List •“debug sflow” on page 3064
•“debug sflow agent” on page 3065
•“sflow agent (address)” on page 3066
•“sflow collector (address)” on page 3068
•“sflow collector max-datagram-size” on page 3070
•“sflow enable” on page 3071
•“sflow max-header-size” on page 3072
•“sflow polling-interval” on page 3074
•“sflow sampling-rate” on page 3075
•“show debugging sflow” on page 3076
•“show running-config sflow” on page 3078
•“show sflow” on page 3079
•“show sflow interface” on page 3081
•“undebug sflow” on page 3082