C613-50100-01 REV C Command Reference for x930 Series 1736
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PIM-SM COMMANDS
IP
PIM REGISTER-RP-REACHABILITY
ip pim register-rp-reachability
Overview Use this command to enable the RP reachability check for PIM Register processing
at the DR. The default setting is no checking for RP-reachability.
Use the no variant of this command to disable this processing.
Syntax
ip pim register-rp-reachability
no ip pim register-rp-reachability
Default This command is disabled; by default, there is no checking for RP-reachability.
Mode Global Configuration
Example
awplus# configure terminal
awplus(config)# ip pim register-rp-reachability
To Next Page
Loading...
