C613-50100-01 REV C Command Reference for x930 Series 2475
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
VRRP COMMANDS
DISABLE
(VRRP)
disable (VRRP)
Overview Use this command to disable a VRRP IPv4 session or a VRRPv3 IPv6 session on the
router to stop it participating in virtual routing. Note that when this command is
configured then a backup router assumes the role of master router depending on
its priority. See the enable (VRRP) command to enable a VRRP IPv4 session or a
VRRPv3 IPv6 session on the router.
Syntax
disable
Mode Router Configuration
Usage See the VRRP Feature Overview and Configuration Guide for more information
about VRRPv3 IPv4 and IPv6 configuration details.
Examples The example below shows you how to disable the VRRP session for VRRP VR ID 5
on vlan2:
awplus# configure terminal
awplus(config)# router vrrp 5 vlan2
awplus(config-router)# disable
The example below shows you how to disable the VRRPv3 session for VRRPv3 VR
ID 3 on vlan1:
awplus# configure terminal
awplus(config)# router ipv6 vrrp 3 vlan1
awplus(config-router)# disable
Related
Commands
enable (VRRP)
router vrrp (interface)
router ipv6 vrrp (interface)
show vrrp
To Next Page
Loading...
Need help?
General
