C613-50100-01 REV C Command Reference for x930 Series 999
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
OSPF COMMANDS
IP
OSPF RETRANSMIT-INTERVAL
ip ospf retransmit-interval
Overview Use this command to specify the time between link-state advertisement (LSA)
retransmissions for adjacencies belonging to the interface.
Use the no variant of this command to return to the default of 5 seconds.
Syntax
ip ospf [<ip-address>] retransmit-interval <1-65535>
no ip ospf [<ip-address>] retransmit-interval
Default The default interval is 5 seconds.
Mode Interface Configuration for a VLAN interface.
Usage After sending an LSA to a neighbor, the router keeps the LSA until it receives an
acknowledgment. In case the router does not receive an acknowledgment during
the set time (the retransmit interval value) it retransmits the LSA. Set the
retransmission interval value conservatively to avoid needless retransmission. The
interval should be greater than the expected round-trip delay between two
routers.
Example The following example shows setting the ospf retransmit interval to 6
seconds on the VLAN interface vlan2.
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ip ospf retransmit-interval 6
Parameter Description
<ip-address> The IP address of the interface.
<1-65535> Specifies the interval in seconds.
To Next Page
Loading...
Need help?
General
