Allied Telesis AlliedWare Plus - Recv-Buffer-Size (RIP)

C613-50100-01 REV C Command Reference for x930 Series 902
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
RIP COMMANDS
RECV
-BUFFER-SIZE (RIP)
recv-buffer-size (RIP)
Overview Use this command to run-time configure the RIP UDP (User Datagram Protocol)
receive-buffer size to improve UDP reliability by avoiding UDP receive buffer
overrun.
Use the no variant of this command to reset the configured RIP UDP receive-buffer
size to the system default (196608 bits).
Syntax
recv-buffer-size <8192-2147483647>
no recv-buffer-size [<8192-2147483647>]
Default 196608 bits is the system default when reset using the no variant of this command.
Mode Router Configuration
Examples To run-time configure the RIP UDP, use the following commands:
awplus# configure terminal
awplus(config)# router rip
awplus(config-router)# recv-buffer-size 23456789
awplus# configure terminal
awplus(config)# router rip
awplus(config-router)# no recv-buffer-size 23456789
Parameter Description
<8192-2147483647> Specify the RIP UDP (User Datagram Protocol) buffer size
value in bits.