C613-50100-01 REV C Command Reference for x930 Series 3011
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
TRIGGER COMMANDS
SHOW
TRIGGER
show trigger
Overview This command displays configuration and diagnostic information about the
triggers configured on the device. Specify the show trigger command without
any options to display a summary of the configuration of all triggers.
Syntax
show trigger [<1-250>|counter|full]
Mode Privileged Exec
Example To get summary information about all triggers, use the following command:
awplus# show trigger
Parameter Description
<1-250> Displays detailed information about a specific trigger, identified by its
trigger ID.
counter Displays statistical information about all triggers.
full Displays detailed information about all triggers.
Table 1: Example output from the show trigger command
awplus#show trigger
TR# Type & Details Name Ac Te Tr Repeat #Scr Days/Date
---------------------------------------------------------------------------------
001 Card (in) Y N Y Continuous 0 smtwtfs
002 Card (out) Y N Y Continuous 0 smtwtfs
003 CPU (80% any) Busy CPU Y N Y 5 1 smtwtfs
005 Periodic (30 min) Regular status check Y N N Continuous 1 -mtwtf-
007 Memory (85% up) High mem usage Y N Y 8 1 smtwtfs
011 Time (00:01) Weekend access Y N Y Continuous 1 ------s
013 Reboot Y N Y Continuous 2 smtwtfs
017 Interface (vlan1 ... Change config for... Y N Y Once 1 2-apr-2016
019 Ping-poll (5 up) Connection to svr1 Y N Y Continuous 1 smtwtfs
---------------------------------------------------------------------------------
Table 2: Parameters in the output of the show trigger command
Parameter Description
TR# Trigger identifier (ID).
Type &
Details
The trigger type, followed by the trigger details in brackets.
Name Descriptive name of the trigger configured with the description
(trigger) command.