C613-50100-01 REV C Command Reference for x930 Series 2576
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ALLIED TELESIS MANAGEMENT FRAMEWORK™ (AMF) COMMANDS
ATMF
MTU
atmf mtu
Overview This command configures the ATMF network Maximum Transmission Unit (MTU).
The MTU value will be applied to the ATMF Management VLAN, the ATMF Domain
VLAN and ATMF Area links.
Use the no variant of this command to restore the default MTU.
Syntax
atmf mtu <1300-1442>
no atmf mtu
Default 1300
Mode Global Configuration
Usage The default value of 1300 will work for all AMF networks (including those that
involve virtual links over IPsec tunnels). If there are virtual links over IPsec tunnels
anywhere in the AMF network, we recommend not changing this default. If there
are no virtual links over IPsec tunnels, then this AMF MTU value may be increased
for network efficiency.
Example To change the ATMF network MTU to 1442, use the command:
awplus(config)# atmf mtu 1442
Related
Commands
show atmf detail
Parameter Description
<1300-1442> The value of the maximum transmission unit for the
AMF network, which sets the maximum size of all
ATMF packets generated from the device.
To Next Page
Loading...
Need help?
General
