C613-50100-01 REV C Command Reference for x930 Series 2746
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
DYNAMIC HOST CONFIGURATION PROTOCOL (DHCP) COMMANDS
SHOW
IP DHCP POOL
lease
<days:hours:minutes>
The lease duration for address allocated by this
pool.
domain The domain name sent by the pool to clients. This is
the domain name that the client should use when
resolving host names using DNS.
subnet mask The subnet mask sent by the pool to clients.
Probe - Status Whether lease probing is enabled or disabled.
Probe - Type The lease probe type configured. Either ping or ARP.
Probe - Packets The number of packets sent for each lease probe in
the range 0 to 10.
Probe - Timeout The timeout value in milliseconds to wait for a
response after each probe packet is sent. In the
range 50 to 5000.
dns servers The DNS server addresses sent to by the pool to
clients.
default-router(s) The default router addresses sent by the pool to
clients.
user-defined options The list of user-defined options sent by the pool to
clients.
Dynamic addresses-
Total
The total number of IP addresses that have been
configured in the pool for dynamic allocation to
DHCP clients.
Dynamic addresses-
Leased
The number of IP addresses in the pool that have
been dynamically allocated (leased) to DHCP
clients.
Dynamic addresses -
Utilization
The percentage of IP addresses in the pool that are
currently dynamically allocated to clients.
Static host addresses-
Total
The number of static IP addresses configured in the
pool for specific DHCP client hosts.
Static host addresses
- Leased
The number of static IP addresses assigned to
specific DHCP client hosts.
Table 3: Parameters in the output of the show ip dhcp pool command (cont.)
Parameter Description
To Next Page
Loading...
Need help?
General
