C613-50100-01 REV C Command Reference for x930 Series 1596
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IGMP AND IGMP SNOOPING COMMANDS
IP
IGMP LAST-MEMBER-QUERY-COUNT
ip igmp last-member-query-count
Overview Use this command to set the last-member query-count value for an interface.
Use the no variant of this command to return to the default on an interface.
Syntax
ip igmp last-member-query-count <2-7>
no ip igmp last-member-query-count
Default The default last member query count value is 2.
Mode Interface Configuration for a VLAN interface.
Usage This command applies to VLAN interfaces configured for IGMP, IGMP Snooping, or
IGMP Proxy.
Example To set the last-member query-count to 3 on vlan2, use the commands:
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ip igmp last-member-query-count 3
Related
Commands
ip igmp last-member-query-interval
ip igmp startup-query-count
show ip igmp interface
show running-config
Parameter Description
<2-7> Last member query count value.
To Next Page
Loading...
Need help?
General
