EasyManuals Logo

Allied Telesis AlliedWare Plus User Manual

Allied Telesis AlliedWare Plus
3082 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2132 background imageLoading...
Page #2132 background image
C613-50100-01 REV C Command Reference for x930 Series 2132
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
AUTHENTICATION COMMANDS
AUTH
TWO-STEP ENABLE
auth two-step enable
Overview This command enables a two-step authentication feature on an interface. When
this feature is enabled, the supplicant is authorized in a two-step process. If
authentication succeeds, the supplicant becomes authenticated. This command
will apply the two-step authentication method based on 802.1X-, MAC- or
Web-Authentication.
The no variant of this command disables the two-step authentication feature.
Syntax
auth two-step enable
no auth two-step enable
Default Two step authentication is disabled by default.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port; or Authentication Profile mode.
Usage The single step authentication methods (either user or device authentication) have
a potential security risk:
an unauthorized user can access the network with an authorized device, or
an authorized user can access the network with an unauthorized device.
Two-step authentication solves this problem by authenticating both the user and
the device. The supplicant will only become authenticated if both these steps are
successful. If the first authentication step fails, then the second step is not started.
Examples To enable the two step authentication feature, use the following commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# auth two-step enable
To disable the two step authentication feature, use the following commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# no auth two-step enable
To enable MAC-Authentication followed by 802.1X-Authentication, use the
following commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# switchport mode access
awplus(config-if)# auth-mac enable
awplus(config-if)# dot1x port-control auto
awplus(config-if)# auth dynamic-vlan-creation
awplus(config-if)# auth two-step enable

Table of Contents

Other manuals for Allied Telesis AlliedWare Plus

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allied Telesis AlliedWare Plus and is the answer not in the manual?

Allied Telesis AlliedWare Plus Specifications

General IconGeneral
BrandAllied Telesis
ModelAlliedWare Plus
CategorySwitch
LanguageEnglish

Related product manuals