C613-50100-01 REV C Command Reference for x930 Series 3049
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PING-POLLING COMMANDS
PING
-POLL
ping-poll
Overview This command enters the ping-poll configuration mode. If a ping-poll exists with
the specified number, then this command enters its configuration mode. If
no-ping poll exists with the specified number, then this command creates a new
ping poll with this ID number.
To configure a ping-poll, create a ping poll using this command, and use the ip
(ping-polling) command to specify the device you want the polling instance to
poll. It is not necessary to specify any further commands unless you want to
change a command’s default.
The no variant of this command deletes the specified ping poll.
Syntax
ping-poll <1-100>
no ping-poll <1-100>
Mode Global Configuration
Examples To create ping-poll instance 3 and enter ping-poll configuration mode, use the
commands:
awplus# configure terminal
awplus(config)# ping-poll 3
awplus(config-ping-poll)#
To delete ping-poll instance 3, use the commands:
awplus# configure terminal
awplus(config)# no ping-poll 3
Related
Commands
active (ping-polling)
clear ping-poll
debug ping-poll
description (ping-polling)
ip (ping-polling)
length (ping-poll data)
show ping-poll
source-ip
Parameter Description
<1-100> A unique ping poll ID number.
To Next Page
Loading...
Need help?
General
