29
C613-50100-01 REV C Command Reference for x930 Series 1434
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Route Map
Commands
Introduction
Overview This chapter provides an alphabetical reference for route map commands. These
commands can be divided into the following categories:
• route-map command, used to create a route map and/or route map entry,
and to put you into route map mode
• match commands, used to determine which routes or BGP update messages
the route map applies to
• set commands, used to modify matching routes or BGP update messages
Command List •“match as-path” on page 1436
•“match community” on page 1437
•“match interface” on page 1439
•“match ip address” on page 1440
•“match ip next-hop” on page 1443
•“match ipv6 address” on page 1445
•“match ipv6 next-hop” on page 1446
•“match metric” on page 1447
•“match origin” on page 1448
•“match route-type” on page 1450
•“match tag” on page 1451
•“route-map” on page 1452
•“set aggregator” on page 1455
•“set as-path” on page 1456
•“set atomic-aggregate” on page 1457
•“set comm-list delete” on page 1458
To Next Page
Loading...
Need help?
General
