C613-50100-01 REV C Command Reference for x930 Series 2010
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
QOS COMMANDS
MLS
QOS COS
mls qos cos
Overview This command assigns a CoS (Class of Service) user-priority value to untagged
frames entering a specified interface. By default, all untagged frames are assigned
a CoS value of 0.
Use the no variant of this command to return the interface to the default CoS
setting for untagged frames entering the interface.
Syntax
mls qos cos <0-7>
no mls qos cos
Default By default, all untagged frames are assigned a CoS value of 0. Note that for tagged
frames, the default behavior is not to alter the CoS value.
Mode Interface Configuration
Example To assign a CoS user priority value of 2 to all untagged packets entering ports 1.0.1
to 1.0.6, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.1-port1.0.6
awplus(config-if)# mls qos cos 2
Parameter Description
<0-7> The Class of Service, user-priority value.
To Next Page
Loading...
Need help?
General
