C613-50100-01 REV C Command Reference for x930 Series 1358
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
BGP AND BGP4+ COMMANDS
NETWORK
(BGP AND BGP4+)
network (BGP and BGP4+)
Overview Use this command to specify particular routes to be advertised into the BGP or
BGP4+ routing process. A unicast network address without a mask is accepted if it
falls into the natural boundary of its class. A class-boundary mask is derived if the
address matches its natural class-boundary.
Note that you can specify a prefix length for the prefix being added, and you can
also specify a classful network without a prefix length and an appropriate prefix
length is added. Note that specifying a non-classful prefix without a prefix length
results in a /32 prefix length on an IPv4 route.
Use the no variant of this command to remove a network route entry.
Syntax [BGP]
network {<ip-prefix/length>|<ip-network-addr>} [mask
<network-mask>] [route-map <route-map-name>] [backdoor]
no network {<ip-prefix/length>|<ip-network-addr>} [mask
<network-mask>] [route-map <route-map-name>] [backdoor]
Syntax [BGP4+] network {<ipv6-prefix/length>|<ipv6-network-addr>} [route-map
<route-map-name>]
no network {<ipv6-prefix/length>|<ipv6-network-addr>}
[route-map <route-map-name>]
Mode [BGP] Router Configuration and IPv4 Address Family [ipv4 unicast] mode
Mode [BGP4+] IPv6 Address Family Configuration
Parameter Description
<ip-prefix/length> IP network prefix and prefix length entered in dotted
decimal format for the IP network prefix, then slash
notation for the prefix length in the format A.B.C.D/M, e.g.
192.168.1.224/27
<ip-network-addr> IP network prefix entered in dotted decimal format
A.B.C.D, e.g. 192.168.1.224
<network-mask> Specify a network mask in the format A.B.C.D, e.g.
255.255.255.224.
<ipv6-prefix/
length>
IPv6 network prefix and prefix length entered in dotted
decimal format for the IPv6 network prefix, then slash
notation for the IPv6 prefix length in the format X:X::X:X/
M, e.g. 2001:db8::/64
<ipv6-network-addr> IP network prefix entered in dotted decimal format
A.B.C.D, e.g. 192.168.1.224
<route-map-name> Specify the name of the route map.
backdoor Specify a BGP backdoor route that is not advertised.
To Next Page
Loading...
Need help?
General
