EasyManuals Logo

Allied Telesis AlliedWare Plus User Manual

Allied Telesis AlliedWare Plus
3082 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1473 background imageLoading...
Page #1473 background image
C613-50100-01 REV C Command Reference for x930 Series 1473
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ROUTE MAP COMMANDS
SET
TAG
set tag
Overview Use this command to add a tag set clause to a route map entry.
When a route matches the route map entry, the device sets its tag to the specified
value when it redistributes the route into OSPF.
Use the no variant of this command to remove the set clause.
Syntax
set tag <tag-value>
no set tag [<tag-value>]
Mode Route-map Configuration
Usage This command is valid only when redistributing routes into OSPF.
Example To use entry 3 of the route map called rmap1 to tag matching routes with the
number 6, use the commands:
awplus# configure terminal
awplus(config)# route-map rmap1 permit 3
awplus(config-route-map)# set tag 6
Related
Commands
default-information originate
redistribute (OSPF)
match tag
route-map
show route-map
Parameter Description
<tag-value> <0-4294967295>
Value to tag matching routes with.

Table of Contents

Other manuals for Allied Telesis AlliedWare Plus

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allied Telesis AlliedWare Plus and is the answer not in the manual?

Allied Telesis AlliedWare Plus Specifications

General IconGeneral
BrandAllied Telesis
ModelAlliedWare Plus
CategorySwitch
LanguageEnglish

Related product manuals