36
C613-50100-01 REV C Command Reference for x930 Series 1827
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PIM-DM Commands
Introduction
Overview This chapter provides an alphabetical reference of PIM-DM commands. For
commands common to PIM-SM and PIM-DM, see Multicast Commands.
Command List •“debug pim dense-mode all” on page 1829
•“debug pim dense-mode context” on page 1830
•“debug pim dense-mode decode” on page 1831
•“debug pim dense-mode encode” on page 1832
•“debug pim dense-mode fsm” on page 1833
•“debug pim dense-mode mrt” on page 1834
•“debug pim dense-mode nexthop” on page 1835
•“debug pim dense-mode nsm” on page 1836
•“debug pim dense-mode vif” on page 1837
•“ip pim dense-mode” on page 1838
•“ip pim dense-mode passive” on page 1839
•“ip pim ext-srcs-directly-connected (PIM-DM)” on page 1840
•“ip pim hello-holdtime (PIM-DM)” on page 1841
•“ip pim hello-interval (PIM-DM)” on page 1842
•“ip pim max-graft-retries” on page 1843
•“ip pim neighbor-filter (PIM-DM)” on page 1845
•“ip pim propagation-delay” on page 1846
•“ip pim state-refresh origination-interval” on page 1847
•“show debugging pim dense-mode” on page 1848
•“show ip pim dense-mode interface” on page 1849
To Next Page
Loading...
Need help?
General
