C613-50100-01 REV C Command Reference for x930 Series 884
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
RIP COMMANDS
IP
RIP RECEIVE-PACKET
ip rip receive-packet
Overview Use this command to configure the interface to enable the reception of RIP
packets.
Use the no variant of this command to disable this feature.
Syntax
ip rip receive-packet
no ip rip receive-packet
Default Receive-packet is enabled
Mode Interface Configuration for a VLAN interface.
Usage This command can only be configured on VLAN interfaces.
Example This example shows packet receiving being turned on for the VLAN interface
vlan3:
awplus# configure terminal
awplus(config)# interface vlan3
awplus(config-if)# ip rip receive-packet
Related
Commands
ip rip send-packet
To Next Page
Loading...
Need help?
General
