C613-50100-01 REV C Command Reference for x930 Series 2796
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
DHCP FOR IPV6 (DHCPV6) COMMANDS
SHOW
IPV6 DHCP BINDING
show ipv6 dhcp binding
Overview Use this command in User Exec or Privileged Exec mode to show the IPv6 address
entries that the DHCPv6 server leases to DHCPv6 clients. Note that applying this
command with the optional summary keyword parameter displays the number of
addresses per pool, but not the address or prefix entries per pool.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show ipv6 dhcp binding [summary]
Mode User Exec and Privileged Exec
Example 1 To display the total DHCPv6 leasing address entries for all pools, use the command:
awplus# show ipv6 dhcp binding summary
Output Figure 56-5: Example output from the show ipv6 dhcp binding summary
command
Parameter Description
summary Optional. Specify the summary keyword to display summarized
information for DHCPv6 server leases to client nodes, displaying the
number of address entries per pool, not the addresses or prefixes.
awplus# show ipv6 dhcp binding summary
Pool Name Number of Leased Addresses
----------------------------------------------------
ia-na1 3
ia-pd1 5
Total in all Pools: 8
Table 3: Parameters in the output of the show ipv6 dhcp binding summary
command
Parameter Description
Pool Name Displays a list of all the pool names.
Number of
Leased
Addresses
Displays the number of leased address entries for the pool.
Total in all
Pools
Displays the total number of leased address entries for all pools.
To Next Page
Loading...
Need help?
General
